Notice! This event has been cancelled. Registrations have been automatically cancelled and payments refunded, if applicable.
When Wed Dec 12 10:30pm — 11:59pm
Where 3D Fabrication Room
1825 Monetary Ln #104 Carrollton, TX 75006
What [Midnight Maker] Create stunning, detailed prints on our SLA printer
Host Matthew Dailey


  • Cost: Free
  • Restrictions:
    • DMS members only
    • Ages 16+

Cancellations for this event must be made before December 12, 2018 — 10:30pm.

Registration for the event is closed.

About this Event

Get signed off to use our wonderful high resolution SLA Resin printer, the Form 2 "Serious Mink!" This class is completely independent of 3D Fab 101, so feel free to sign up even if you're new to the world of 3D Fab!

This late-evening class will train you to use the Form 2 FormLabs printer.
1. Familiarize you with the available resins
2. Procedures and care needed
3. Prep your model in Pre-Form software
4. Load resin, start model
5. Clean up Resin
6. Finish and Cure models

Special Considerations and Warnings

No food allowed in 3D Fabrication room. Any drinks must have a lid. Caution, uncured resin is toxic!
If you can't make it please cancel or let me know ahead of time.