Notice! This event has been cancelled. Registrations have been automatically cancelled and payments refunded, if applicable.
When Fri Nov 16 11pm — Sat Nov 17 12am
Where 3D Fabrication Room
1825 Monetary Ln #104 Carrollton, TX 75006
What [Midnight Maker] Create stunning, detailed prints on our SLA printer
Host Matthew Dailey


  • Cost: Free
  • Restrictions:
    • DMS members only
    • Ages 16+

Cancellations for this event must be made before November 16, 2018 — 11:00pm.

Registration for the event is closed.

About this Event

Learn to use our wonderful high resolution SLA Resin printer, the Form 2 "Serious Mink"

This late-evening class will train you to use the Form 2 FormLabs printer.
1. Familiarize you with the available resins
2. Procedures and care needed
3. Prep your model in Pre-Form software
4. Load resin, start model
5. Clean up Resin
6. Finish and Cure models

Special Considerations and Warnings

No food allowed in 3D Fabrication room. Any drinks must have a lid. Caution, uncured resin is toxic!