Sat Dec 7 12pm —
Laser - Thunder
1825 Monetary Ln #104 Carrollton, TX 75006
||Learn how to use our Thunder Laser cutters.
- Cost: Free
- DMS members only
- Ages 16+
Cancellations for this event must be made before December 7, 2019 — 12:00pm.
Registration for the event is closed.
About this Event
Learn how to use our Thunder Laser cutters. This class fulfills the training required for using the Thunder Laser cutters.
We'll spend 30- 45 minutes talking about laser cutters, about raster and vector cuts, which material you can and can't use. Next, we will walk through the procedure for getting your material setup and ready to cut, with a special emphasis on safety. Then we'll use the RDWorks software to open a file that contains an image we'll cut on the Thunder Laser.
Documentation is available at dallas.ms/wiki. Search for Laser Committee
Special Considerations and Warnings
After this class you will be signed off for Laser 101 Thunder Basics.
This class uses RDWorks to load jobs.
Occasionally I find that someone is registered for a couple of Laser 101 classes on different dates. The idea is probably that if they can’t make the first one, they have a backup. Since these classes are usually full, it often results in two other people not getting those spots that are reserved by one person. Please register for only one Laser 101 - Thunder Basics class at a time.